Lewbath soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lewbath shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lewbath soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lewbath spot on the map
Rated from the USDA soil survey record for Lewbath flaggy loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A flaggy loam layer about 0 to 9 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A flaggy silt loam layer about 9 to 15 in down: about 12% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw2 A flaggy silt loam layer about 15 to 25 in down: about 14% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerE A channery loam layer about 25 to 29 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBxbest layer A very flaggy silt loam layer about 29 to 52 in down: about 16% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerC A very flaggy silt loam layer about 52 to 72 in down: about 14% clay, moderate plasticity when wet, olive brown when moist. Weak indication
What it looks like raw
The sandy layer (Bx), 29 to 52 in down in the typical profile: dark grayish brown (2.5Y 4/2); very firm and brittle. Raw colour is not fired colour.
About the soil
- Parent material: brownish loamy till derived from gray and brown sandstone, siltstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Higher elevations of MLRA 140. The series is moderately extensive.
USDA, geographic setting: Lewbath soils are on uplands of glaciated dissected plateaus and till plains and mainly occur on convex hilltops and hillsides. Slopes range from 3 to 55 percent. The soils developed in firm till derived from sandstone, siltstone, and shale. Annual air temperature ranges from 4 to 9 degrees C (39 to 48 degrees F). Annual precipitation ranges from 825 to 1790 mm (32 to 70 in) and the frost free days range from 110 to 155 days. Elevation ranges from 425 to 1100 m (1394 to 3608 ft) above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
- Mongaup: Weak indication
- Norchip: Weak indication
See it on the map
Open a Lewbath spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lewbath flaggy loam, 3 to 8 percent slopes, map unit LeB in Delaware County, New York.
- Official Series Description: Lewbath(revised 07/2015), established.
- Taxonomic class: Coarse-loamy, mixed, semiactive, frigid Typic Fragiudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.