Willamette soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 24 to 54 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Willamette soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Willamette spot on the map
Rated from the USDA soil survey record for Willamette silt loam, 0 to 3 percent slopes (Marion County Area, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 24 in down: about 24% clay, moderate plasticity when wet, very dark grayish brown when moist. Possible
- Loamy layerH2best layer A silt loam layer about 24 to 54 in down: about 27% clay, high plasticity when wet, dark brown when moist. Promising
- Loamy layerH3 A silt loam layer about 54 to 65 in down: about 25% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 24 to 54 in down in the typical profile: dark brown (10YR 3/3), brown (10YR 5/3) dry; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Marion County Area, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: The Willamette Valley of Oregon and southwestern Washington; MLRA 2. The series is of moderate extent.
USDA, geographic setting: Willamette soils are on level to gently sloping broad valley terraces 2 to 50 feet higher than the valley flood plain at elevations of 150 to 400 feet. Slopes are 0 to 20 percent. The soils formed in indistinctly stratified silty alluvium of mixed materials or lacustrine silts of upper Pleistocene age. Beginning at the surface of the mineral soil, the depositional stratigraphy of the Willamette soil profile developed in the following Willamette Formation Members: (1) Greenback Member, and (2) Irish Bend Member. The climate is humid temperate. The average annual precipitation is 40 to 50 inches. The average annual temperature is 50 to 54 degrees F., the average January temperature is 39 to...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bashaw: Strong lead
- Concord: Strong lead
- Dayton: Strong lead
- Holcomb: Strong lead
- Labish: Strong lead
- McBee: Strong lead
- Amity: Promising
- Chehalis: Promising
See it on the map
Open a Willamette spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 83%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Willamette silt loam, 0 to 3 percent slopes, map unit WlA in Marion County Area, Oregon.
- Official Series Description: Willamette(revised 08/2006), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Pachic Ultic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.