Concord soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 15 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Concord soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Concord spot on the map
Rated from the USDA soil survey record for Concord silt loam (Marion County Area, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 15 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Possible
- Clay-rich layerH2best layer A silty clay layer about 15 to 29 in down: about 43% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Loamy layerH3 A silt loam layer about 29 to 60 in down: about 27% clay, moderate plasticity when wet, dark grayish brown when moist. Promising
What it looks like raw
The clay-rich layer (H2), 15 to 29 in down in the typical profile: grayish brown (2.5Y 5/2), light brownish gray (2.5Y 6/2) dry; extremely hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed mineralogy alluvium.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Marion County Area, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: On broad terraces of the Willamette Valley, Oregon; MLRA 2. The series is of moderate extent.
USDA, geographic setting: The Concord soils are on terraces at elevations between 150 and 400 feet. Slopes are dominantly less than 1 percent but may reach 2 percent. The soils formed in stratified silty and clayey glaciolacustrine deposits of mixed mineralogy. The mean annual precipitation is 40 to 50 inches. The average January temperature is 39 to 40 degrees F. and the average July temperature is 65 to 67 degrees F. The mean annual temperature is 50 to 54 degrees F. The frost-free period is 165 to 210 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bashaw: Strong lead
- Dayton: Strong lead
- Holcomb: Strong lead
- Labish: Strong lead
- McBee: Strong lead
- Amity: Promising
- Chehalis: Promising
- Wapato: Promising
See it on the map
Open a Concord spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Concord silt loam, map unit Co in Marion County Area, Oregon.
- Official Series Description: Concord(revised 07/2006), established.
- Taxonomic class: Fine, smectitic, mesic Typic Endoaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.