McBee soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 42 to 65 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about McBee soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for McBee silty clay loam, 0 to 3 percent slopes (Yamhill County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 3% by volume).
- Note High shrink-swell (linear extensibility about 7%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilAp A silty clay loam layer about 0 to 7 in down: about 29% clay, moderate plasticity when wet, very dark brown when moist. Possible
- TopsoilA A silty clay loam layer about 7 to 10 in down: about 29% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- Loamy layerBA A silty clay loam layer about 10 to 22 in down: about 32% clay, high plasticity when wet, very dark brown when moist. Promising
- Loamy layerBw A silty clay loam layer about 22 to 35 in down: about 32% clay, high plasticity when wet, dark grayish brown when moist. Promising
- Loamy layerBCg A clay loam layer about 35 to 42 in down: about 32% clay, high plasticity when wet, dark grayish brown when moist. Promising
- Clay-rich layerCgbest layer A clay loam layer about 42 to 65 in down: about 35% clay, high plasticity when wet, dark gray when moist. Strong lead
What it looks like raw
The clay-rich layer (Cg), 42 to 65 in down in the typical profile: dark gray (10YR 4/1), gray (10YR 5/1) dry. Raw colour is not fired colour.
About the soil
- Parent material: silty and loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Marion County Area, Oregon; Yamhill County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Northern Willamette Valley in Oregon and western Washington; MLRA 2, 5. The series is moderately extensive.
USDA, geographic setting: The McBee soils are at elevations of 25 to 1,000 feet in flat depressed terrraces often some distance from large streams, and in flat flood plain areas adjacent to small streams. The soils formed in silty and loamy alluvium from mixed sedimentary and igneous sources. The climate is characterized by warm, wet winters and hot, dry summers. The mean annual precipitation is 40 to 60 inches. The mean annual temperature is 50 to 54 degrees F. The mean January temperature is 39 to 40 degrees F. and the mean July temperature is 65 to 67 degrees F. The frost-free period is 160 to 210 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bashaw: Strong lead
- Concord: Strong lead
- Dayton: Strong lead
- Holcomb: Strong lead
- Labish: Strong lead
- Chehalis: Promising
- Wapato: Promising
- Amity: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 87%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for McBee silty clay loam, 0 to 3 percent slopes, map unit 2006A in Yamhill County, Oregon.
- Official Series Description: McBee(revised 08/2006), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Aquic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.