Valois soil
Wild-clay potential
Weak indication
Weak indication: no layer of Valois shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Valois soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Valois very fine sandy loam, 3 to 8 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (3.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A very fine sandy loam layer about 0 to 4 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerE A very fine sandy loam layer about 4 to 5 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw1 A gravelly silt loam layer about 5 to 15 in down: about 12% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBw2 A gravelly silt loam layer about 15 to 31 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layer2Cbest layer A very gravelly fine sandy loam layer about 31 to 72 in down: about 10% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (2C), 31 to 72 in down in the typical profile: dark grayish brown (10YR 4/2); very gravelly fine sandy loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy till derived mainly from sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 9 map units in New York, in these survey areas: Delaware County, New York; Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Glaciated Allegheny Plateau of New York and Pennsylvania, and locally in the Hudson Valley and Mohawk Valley of New York. MLRA 101, 140, and 144A. The series is moderately extensive.
USDA, geographic setting: Valois soils are typically on complex slopes characteristic of end or lateral moraines. Some landforms are congeliturbate covered or till covered valley terraces. Slope ranges from 0 to 60 percent. They formed in till dominated by material from sandstone and siltstone or shale with some slate or phyllite and typically have a small component of material from calcareous rocks. The till commonly is calcareous at depths greater than 12 feet. Fluvial sorting in the substratum commonly results in weak stratification. Mean annual temperature ranges from 46 to 50 degrees F., mean annual precipitation ranges from 30 to 45 inches, and mean annual frost-free days ranges from 120 to 180 days....
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Lewbath: Weak indication
- Lordstown: Weak indication
- Mardin: Weak indication
- Mongaup: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Valois very fine sandy loam, 3 to 8 percent slopes, map unit VaB in Delaware County, New York.
- Official Series Description: Valois(revised 02/2012), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.