Unadilla soil
Wild-clay potential
Weak indication
Weak indication: no layer of Unadilla shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Unadilla soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Unadilla spot on the map
Rated from the USDA soil survey record for Unadilla silt loam (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 22 in (56 cm)).
- Lowers the potential Typically starts about 50 in (127 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 6 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilAB A silt loam layer about 6 to 15 in down: about 12% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerBw1 A silt loam layer about 15 to 34 in down: about 12% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerBw2 A very fine sandy loam layer about 34 to 39 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw3 A silt loam layer about 39 to 50 in down: about 12% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layer2Cbest layer A loamy sand layer about 50 to 72 in down: about 5% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (2C), 50 to 72 in down in the typical profile: dark grayish brown (10YR 4/2); stratified very gravelly sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: glaciolacustrine deposits, eolian deposits, or old alluvium, comprised mainly of silt and very fine sand.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in New York, Pennsylvania, in these survey areas: Delaware County, New York; Warren and Forest Counties, Pennsylvania.
By state: wild clay in New York,wild clay in Pennsylvania.
USDA, distribution and extent: Southern and western New York, northern Pennsylvania, Massachusetts, New Hampshire, New Jersey and Vermont. MLRA's 101, 140, 144A, 144B, and 145. The series is moderately extensive.
USDA, geographic setting: The Unadilla soils are typically on terrace positions in valleys, but they are also on undulating to rolling lake plains. Slope ranges from 0 to 50 percent. The soils formed in water or wind-deposited material that is high in coarse silt and very fine sand. Typically, the soils are less than 5 feet thick, and are underlain by sand and gravel. In places the silt mantle is underlain by till. Mean annual precipitation ranges from 32 to 40 inches; mean annual temperature ranges from 45 to 49 degrees F.; and mean annual frost-free growing season ranges from 120 to 180 days. Elevation ranges from 100 to 1,400 feet above the sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Armagh: Strong lead
- Cavode: Strong lead
- Brinkerton: Promising
- Ernest: Promising
- Shelmadine: Promising
- Wharton: Promising
- Alvira: Possible
- Atkins: Possible
See it on the map
Open a Unadilla spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Unadilla silt loam, map unit Un in Delaware County, New York.
- Official Series Description: Unadilla(revised 05/2013), established.
- Taxonomic class: Coarse-silty, mixed, active, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.