Atkins soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 8 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Atkins soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Atkins silt loam, 0 to 3 percent slopes, frequently flooded (Venango County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (16).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 1 to 2 in down, not a clay body. Weak indication
- TopsoilA A silt loam layer about 2 to 8 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerBgbest layer A loam layer about 8 to 26 in down: about 26% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerBCg A silt loam layer about 26 to 38 in down: about 27% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerCg A gravelly sandy loam layer about 38 to 80 in down: about 19% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The loamy layer (Bg), 8 to 26 in down in the typical profile: grayish brown (10YR 5/2), loam with few fine and medium strong brown (7.5YR 5/6), and strong brown (7.5YR 5/8); friable. Raw colour is not fired colour.
About the soil
- Parent material: acid fine-loamy alluvium derived from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Huntingdon County, Pennsylvania; Schuylkill County, Pennsylvania; Venango County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Indiana, Kentucky, Maryland, New York, Ohio, Pennsylvania, Tennessee, Virginia and West Virginia. Major Land Resource Areas (MLRA's) include: 124, 125, 126, 127, 128, 130A, 130B, 140, and 147. The extent is large.
USDA, geographic setting: Atkins soils are on nearly level soils of flood plains. Slopes are concave or linear and range from 0 to 3 percent. Atkins soils formed in alluvium washed mainly from upland soils derived from interbedded acid sandstones and shales. Average annual precipitation ranges from 950 to 1400 millimeters and average annual temperature ranges from 8 to 13.8 degrees C.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cavode: Strong lead
- Armagh: Strong lead
- Edom: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Ernest: Promising
- Brinkerton: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Atkins silt loam, 0 to 3 percent slopes, frequently flooded, map unit At in Venango County, Pennsylvania.
- Official Series Description: Atkins(revised 04/2025), established.
- Taxonomic class: Fine-loamy, mixed, active, acid, mesic Fluvaquentic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.