Terminal soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 39 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Terminal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Terminal spot on the map
Rated from the USDA soil survey record for Terminal silt loam, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 37% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 30% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA21&A22 A silt loam layer about 0 to 9 in down: about 15% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerB2t&B3ca A silty clay loam layer about 9 to 14 in down: about 33% clay, high plasticity when wet, light brownish gray when moist. Possible
- C1cam An indurated layer about 14 to 16 in down: USDA gives no clay percentage or texture for it. Not enough data
- Loamy layerC2 A silty clay loam layer about 16 to 29 in down: about 31% clay, high plasticity when wet, light gray when moist. Promising
- Sandy layerIIC3 A sand layer about 29 to 39 in down: about 4% clay, low plasticity when wet, pale yellow when moist. Weak indication
- Clay-rich layerIIIC4best layer A silty clay loam layer about 39 to 60 in down: about 37% clay, high plasticity when wet, pale yellow when moist. Strong lead
What it looks like raw
The clay-rich layer (IIIC4), 39 to 60 in down in the typical profile: pale yellow (5Y 8/2), light olive gray (5Y 6/2) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 3,250 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Terminal soils are on lake plains and low lake terraces. These soils formed in calcareous lacustrine deposits derived from mixed rocks. Slopes are 0 to 1 percent. Elevations range from 4,200 to 4,250 feet. The climate is dry subhumid. The mean annual precipitation is 14 to 16 inches. The mean annual temperature is 51 to 53 degrees F., the mean summer temperature is about 70 degrees F., and the frost-free period is 160 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
See it on the map
Open a Terminal spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Terminal silt loam, 0 to 1 percent slopes, map unit Te in Salt Lake Area, Utah.
- Official Series Description: Terminal(revised 12/2005), established.
- Taxonomic class: Loamy, mixed, superactive, mesic, shallow Natric Durixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.