Pintailake soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 10 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pintailake soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pintailake spot on the map
Rated from the USDA soil survey record for Pintailake-Eimarsh-Playas complex, 0 to 1 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 36% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (26): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 21 in (54 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 24% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Organic top layerH1 An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- Loamy layerH2 A silt loam layer about 3 to 10 in down: about 26% clay, moderate plasticity when wet, light olive gray when moist. Possible
- Clay-rich layerH3best layer A silty clay loam layer about 10 to 31 in down: about 36% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay-rich layerH4 A silty clay layer about 31 to 46 in down: about 49% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerH5 A silty clay layer about 46 to 60 in down: about 46% clay, high plasticity when wet, gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H3), 10 to 31 in down in the typical profile: pale brown (10YR 6/3), light gray (10YR 7/2) dry; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah; Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive. MLRA 28A.
USDA, geographic setting: Parent material: Alluvium over lacustrine deposits derived from limestone, shale, and quartzite. Landform: Lake plains. Slope: 0 to 1 percent. Elevation: 4,205 to 4,220 feet. Mean annual temperature: 48 to 52 degrees F. Mean annual precipitation: 12 to 16 inches. Wettest months: October to May. Driest months: June to September. Frost-free period: 140 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Saltair: Strong lead
- Lasil: Strong lead
- Payson: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Bramwell: Strong lead
See it on the map
Open a Pintailake spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pintailake-Eimarsh-Playas complex, 0 to 1 percent slopes, map unit PEP in Box Elder County, Utah, Eastern Part.
- Official Series Description: Pintailake(revised 03/2006), established.
- Taxonomic class: Fine, mixed, active, calcareous, mesic Typic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.