Woods Cross soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 37 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Woods Cross soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Woods Cross spot on the map
Rated from the USDA soil survey record for Woods Cross silty clay loam, 0 to 3 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 37 in (94 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilA11 A silty clay loam layer about 0 to 10 in down: about 31% clay, moderate plasticity when wet, dark gray when moist. Possible
- Clay-rich layerA12 A silty clay loam layer about 10 to 24 in down: about 38% clay, high plasticity when wet, dark gray when moist. Promising
- Clay-rich layerC1g A silty clay loam layer about 24 to 34 in down: about 38% clay, high plasticity when wet, dark gray when moist. Strong lead
- Sandy layerC2g A very fine sandy loam layer about 34 to 37 in down: about 14% clay, low plasticity when wet, dark gray when moist. Weak indication
- Clay-rich layerC3gbest layer A silty clay loam layer about 37 to 60 in down: about 38% clay, high plasticity when wet, light gray when moist. Strong lead
What it looks like raw
The clay-rich layer (C3g), 37 to 60 in down in the typical profile: light gray (5Y 7/1), gray (5Y 5/1) moist; very hard, firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Woods Cross soils are mainly in north central Utah. They are of small extent. MLRA 28A.
USDA, geographic setting: Woods Cross soils are on smooth to slightly undulating, nearly level to gently sloping, broad alluvial fans and flood plains. Slopes are 0 to 3 percent. The soils have formed in alluvium and lake sediments derived from gneiss, schist, granite, quartzite and sandstone. The climate is dry subhumid. The mean annual air temperature ranges from 45 to 52 degrees F (7 to 11 degrees C), the average summer temperature from 65 to 73 degrees F (18 to 23 degrees C), and the frost-free season from 120 to 175 days. The average annual precipitation ranges from 14 to 18 inches (355 to 460 mm).
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
- Goring: Strong lead
See it on the map
Open a Woods Cross spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Woods Cross silty clay loam, 0 to 3 percent slopes, map unit Wo in Box Elder County, Utah, Eastern Part.
- Official Series Description: Woods Cross(revised 11/2025), established.
- Taxonomic class: Fine, smectitic, mesic Cumulic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.