Collett soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 45 to 66 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Collett soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Collett spot on the map
Rated from the USDA soil survey record for Collett silty clay loam, 0 to 2 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 39% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (28): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 21 in (54 cm)).
- Note Typically starts about 45 in (114 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 28% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Clay-rich layerAp A silty clay loam layer about 0 to 7 in down: about 35% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerA1 A silty clay loam layer about 7 to 14 in down: about 35% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerB2 A silty clay layer about 14 to 23 in down: about 44% clay, high plasticity when wet, pale yellow when moist. Strong lead
- Clay-rich layerC1ca A silty clay layer about 23 to 30 in down: about 44% clay, high plasticity when wet, pale yellow when moist. Strong lead
- Clay-rich layerC2ca A silty clay loam layer about 30 to 45 in down: about 38% clay, high plasticity when wet, very pale brown when moist. Strong lead
- Clay-rich layerC3best layer A silty clay loam layer about 45 to 66 in down: about 39% clay, high plasticity when wet, very pale brown when moist. Strong lead
What it looks like raw
The clay-rich layer (C3), 45 to 66 in down in the typical profile: very pale brown (10YR 8/2), pale brown (10YR 6/3) moist; hard, friable, slightly sticky and plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: ow lake terraces in Northern Utah. This series is inextensive.
USDA, geographic setting: Collett soils occur on nearly level to gently sloping low and medium lake terraces at elevations of 4,250 to 4,700 feet. Gradients are 0 to 3 percent. Parent materials are mixed lake sediments. The climate is dry subhumid. The average annual precipitation is 13 to 18 inches. The mean annual temperature is 46 to 51 degrees F., and the mean summer temperature is 68 to 72 degrees F. The frost free season ranges from 120 to 145 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
See it on the map
Open a Collett spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Collett silty clay loam, 0 to 2 percent slopes, map unit Co in Box Elder County, Utah, Eastern Part.
- Official Series Description: Collett(revised 12/2003), established.
- Taxonomic class: Fine, mixed, active, mesic Aquic Calcixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.