Lasil soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 23 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lasil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lasil silt loam, 0 to 1 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 36% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (26): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 22% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 6 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Loamy layerH2 A silt loam layer about 6 to 9 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerH3 A silty clay loam layer about 9 to 13 in down: about 30% clay, high plasticity when wet, light gray when moist. Possible
- Loamy layerH4 A silty clay loam layer about 13 to 19 in down: about 34% clay, high plasticity when wet, light gray when moist. Promising
- Loamy layerH5 A silty clay loam layer about 19 to 23 in down: about 33% clay, high plasticity when wet, light gray when moist. Possible
- Clay-rich layerH6best layer A silty clay loam layer about 23 to 60 in down: about 36% clay, high plasticity when wet, light gray when moist. Strong lead
What it looks like raw
The clay-rich layer (H6), 23 to 60 in down in the typical profile: light gray (5Y 7/2), olive gray (5Y 5/2) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Lasil soils are on smooth to channeled low lake terraces and lake plains. They formed in calcareous lacustrine deposits derived from mixed sedimentary and igneous rocks. Slopes are 0 to 3 percent. Elevations range from 4,200 to 4,500 feet. The climate is dry subhumid. The mean annual precipitation is 12 to 16 inches. The mean annual temperature is 47 to 54 degrees F. and the mean summer temperature is 65 to 75 degrees F. The frost-free period is 120 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Bramwell: Strong lead
- Collett: Strong lead
- Deckerman: Strong lead
- Goring: Strong lead
- Jordan: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lasil silt loam, 0 to 1 percent slopes, map unit Lc in Box Elder County, Utah, Eastern Part.
- Official Series Description: Lasil(revised 12/2005), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Typic Natrixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.