Deckerman soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 43 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Deckerman soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Deckerman spot on the map
Rated from the USDA soil survey record for Deckerman fine sandy loam, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 3% by volume).
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11&A12 A fine sandy loam layer about 0 to 6 in down: about 18% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerC1 A loam layer about 6 to 12 in down: about 23% clay, moderate plasticity when wet, pale brown when moist. Possible
- Loamy layerC2ca A loam layer about 12 to 20 in down: about 23% clay, moderate plasticity when wet, pale brown when moist. Possible
- Sandy layerC3 A sandy loam layer about 20 to 35 in down: about 15% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Loamy layerC4 A loam layer about 35 to 43 in down: about 23% clay, moderate plasticity when wet, light gray when moist. Possible
- Clay-rich layerIIC5best layer A silty clay loam layer about 43 to 60 in down: about 35% clay, high plasticity when wet, light gray when moist. Strong lead
What it looks like raw
The clay-rich layer (IIC5), 43 to 60 in down in the typical profile: light gray (5Y 7/2), light olive gray (5Y 6/2) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 8,700 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Deckerman soils are on lake plains and flood plains. They formed in alluvium and lacustrine deposits derived from sedimentary and igneous rocks. Slopes are 0 to 1 percent. Elevations range from 4,200 to 4,300 feet. The climate is dry subhumid with a mean annual precipitation of 13 to 15 inches. The mean annual temperature is 51 to 53 degrees F. and the mean summer temperature is 65 to 79 degrees F. The frost-free period is 160 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Terminal: Strong lead
See it on the map
Open a Deckerman spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Deckerman fine sandy loam, 0 to 1 percent slopes, map unit De in Salt Lake Area, Utah.
- Official Series Description: Deckerman(revised 03/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Sodic Calcixerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.