Jordan soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 18 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Jordan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Jordan-Saltair complex, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (36): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A silt loam layer about 0 to 2 in down: about 18% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerE A silty clay loam layer about 2 to 5 in down: about 30% clay, high plasticity when wet, light brownish gray when moist. Possible
- Clay subsoilBtn A silty clay loam layer about 5 to 9 in down: about 35% clay, high plasticity when wet, light brownish gray when moist. Promising
- Clay subsoilBtkn1&Btkn2 A silty clay layer about 9 to 18 in down: about 50% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- Clay-rich layerCzg1best layer A silty clay layer about 18 to 43 in down: about 50% clay, high plasticity when wet, light gray when moist. Strong lead
- Loamy layer2Czg2&2Czg3 A silt loam layer about 43 to 60 in down: about 26% clay, moderate plasticity when wet, pale yellow when moist. Possible
What it looks like raw
The clay-rich layer (Czg1), 18 to 43 in down in the typical profile: light gray (2.5Y 7/2), grayish brown (2.5Y 5/2) moist; very hard, firm, moderately sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 9,000 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Jordan soils are on low lake terraces. They formed in lacustrine deposits derived from mixed rocks. Slopes are 0 to 1 percent. Elevations range from 4,200 to 4,580 feet. The climate is dry subhumid with cool, moist winters and warm, dry summers. The mean annual precipitation is 14 to 16 inches. The mean annual temperature is 49 to 52 degrees F. and the average summer temperature is about 70 degrees F. The frost-free period is 140 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Terminal: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Jordan-Saltair complex, 0 to 1 percent slopes, map unit Jo in Salt Lake Area, Utah.
- Official Series Description: Jordan(revised 11/2005), established.
- Taxonomic class: Fine, mixed, active, mesic Calcic Aquisalids
- Rated with rule version 2026-09-28.1; the method is on the About page.