Bramwell soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 47 to 72 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bramwell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bramwell spot on the map
Rated from the USDA soil survey record for Bramwell silty clay loam, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 25 in (64 cm)).
- Note Typically starts about 47 in (119 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA11 A silty clay loam layer about 0 to 2 in down: about 31% clay, moderate plasticity when wet, gray when moist. Possible
- TopsoilA12 A silty clay loam layer about 2 to 8 in down: about 31% clay, moderate plasticity when wet, gray when moist. Promising
- Loamy layerC1ca A silty clay loam layer about 8 to 22 in down: about 31% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- Loamy layerC2ca A silty clay loam layer about 22 to 35 in down: about 31% clay, moderate plasticity when wet, light gray when moist. Promising
- Clay-rich layerC3 A silty clay layer about 35 to 47 in down: about 45% clay, high plasticity when wet, light gray when moist. Strong lead
- Clay-rich layerC4best layer A clay layer about 47 to 72 in down: about 45% clay, high plasticity when wet, light gray when moist. Strong lead
What it looks like raw
The clay-rich layer (C4), 47 to 72 in down in the typical profile: light gray (2.5Y 7/2), grayish brown (2.5Y 5/2) moist; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Southwest Idaho and parts of Nevada and Utah. The series is moderately extensive.
USDA, geographic setting: Bramwell soils are on level to gently sloping low stream or lacustrine terraces and floodplains. They formed in silty alluvium and lacustrine sediments. Slopes are 0 to 4 percent. Elevation is 2,000 to 4,000 feet (605 to 1210 m). Summers are hot and dry and winters are cool and moist. Average annual precipitation is 7 to 12 inches (180 to 305 mm). Average annual temperature is 48 to 54 degrees F (9 to 12 degrees C). Frost-free season is 110 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Magna: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Terminal: Strong lead
See it on the map
Open a Bramwell spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bramwell silty clay loam, 0 to 1 percent slopes, map unit BsA in Salt Lake Area, Utah.
- Official Series Description: Bramwell(revised 12/2025), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Aquic Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.