Magna soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 12 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Magna soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Magna silty clay, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (33): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 28% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA11 A silty clay layer about 0 to 2 in down: about 42% clay, high plasticity when wet, dark gray when moist. Possible
- Clay-rich layerA12 A silty clay layer about 2 to 12 in down: about 45% clay, high plasticity when wet, gray when moist. Promising
- Clay-rich layerC1cagbest layer A silty clay layer about 12 to 28 in down: about 45% clay, high plasticity when wet, light gray when moist. Strong lead
- Clay-rich layerA1b A silty clay loam layer about 28 to 38 in down: about 38% clay, high plasticity when wet, gray when moist. Strong lead
- Loamy layerC2b A silty clay loam layer about 38 to 70 in down: about 34% clay, high plasticity when wet, gray when moist. Promising
What it looks like raw
The clay-rich layer (C1cag), 12 to 28 in down in the typical profile: light gray (5Y 7/1), dark gray (5YR 4/1) moist; very hard, very firm, moderately sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 6,200 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Magna soils occur on smooth to undulating flood plains, lake plains, and low lake terraces. Slopes are 0 to 2 percent. Elevations range from 4,200 to 5,800 feet. The soils formed in alluvium and reworked lacustrine deposits derived from mixed sedimentary and igneous rocks. The climate is dry subhumid. The mean annual precipitation is 10 to 16 inches. The mean annual temperature is 45 to 52 degrees F. and the mean summer temperature is 65 to 75 degrees F. The frost-free period is 120 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bramwell: Strong lead
- Deckerman: Strong lead
- Eimarsh: Strong lead
- Jordan: Strong lead
- Lasil: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Terminal: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Magna silty clay, 0 to 1 percent slopes, map unit Mc in Salt Lake Area, Utah.
- Official Series Description: Magna(revised 02/2006), established.
- Taxonomic class: Fine, mixed, active, mesic Typic Calciaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.