Obray soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 2 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Obray soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Obray clay, 10 to 25 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note Surface layer; expect roots and organic matter.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA11 A clay loam layer about 0 to 2 in down: about 38% clay, moderate plasticity when wet, brown when moist. Promising
- Clay-rich layerA12best layer A clay layer about 2 to 22 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerA1&C1 A clay layer about 22 to 37 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerC2 A clay layer about 37 to 46 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerC3 A clay layer about 46 to 60 in down: about 50% clay, high plasticity when wet, brown when moist. Strong lead
What it looks like raw
The clay-rich layer (A12), 2 to 22 in down in the typical profile: brown (7.5YR 4/2), dark brown (7.5YR 3/3) moist; extremely hard, very firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and colluvium derived from sandstone, quartzite, and limestone.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. The series is inextensive.
USDA, geographic setting: Obray soils occur on gently sloping to moderately steep north and east mountain slopes at elevations of 5,500 to 7,000 feet. Slope gradients are 1 to 20 Percent. In uncultivated areas, gilgai micro-relief is evident. The climate is moist subhumid with warm, dry summers and cold, moist winters. The average annual precipitation is 18 to 25 inches, the mean annual temperature is 42 degrees to 45 degrees F., the mean summer temperature is 62 degrees to 65 degrees F., and the frost-free period is 60 to 110 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Obray clay, 10 to 25 percent slopes, map unit OBE in Box Elder County, Utah, Eastern Part.
- Official Series Description: Obray(revised 03/1999), established.
- Taxonomic class: Fine, smectitic, frigid Typic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.