Manila soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 32 to 42 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Manila soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Manila loam, 10 to 25 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA11,A12 A loam layer about 0 to 13 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerB1 A silty clay loam layer about 13 to 20 in down: about 34% clay, moderate plasticity when wet, brown when moist. Promising
- Clay-rich layerB21t A silty clay layer about 20 to 25 in down: about 45% clay, high plasticity when wet, brown when moist. Promising
- Clay-rich layerB22t A clay layer about 25 to 32 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerB23tbest layer A silty clay layer about 32 to 42 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Loamy layerIIC1ca A very cobbly silt loam layer about 42 to 57 in down: about 23% clay, moderate plasticity when wet, light brown when moist. Weak indication
- BedrockIICR Weathered bedrock about 57 to 67 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (B23t), 32 to 42 in down in the typical profile: brown (7.5YR 5/4), dark brown (7.5YR 4/4) moist; extremely hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium, colluvium, and residuum derived from limestone, quartzite, and sandstone.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 57 in (145 cm) down.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Morgan Area, Utah - Morgan County and Part of Weber County; Summit Area, Utah, Parts of Summit, Salt Lake and Wasatch Counties.
By state: wild clay in Utah.
USDA, distribution and extent: These soils are in the subhumid portions of the Great Basin above ancient Lake Bonneville levels and in the mountain plateau areas of Utah. LRR B, D, E; MLRA 13, 25, 28A, 47. The series is of small extent.
USDA, geographic setting: These soils are at elevations of 4,800 to 8,400 feet, on nearly level to steep alluvial fans, mountain slopes, hills, and fan terraces with slopes of 0 to 50 percent. They formed in colluvium and alluvium from mixed sedimentary rocks. The climate is moist subhumid, having a mean annual temperature of 37 to 45 degrees F., a mean summer temperature of 57 to 62 degrees F., and an average precipitation of 15 to 25 inches. Freeze-free period is between 60 and 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Collett: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Manila loam, 10 to 25 percent slopes, map unit MbE in Box Elder County, Utah, Eastern Part.
- Official Series Description: Manila(revised 07/1999), established.
- Taxonomic class: Fine, smectitic, frigid Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.