Ant Flat soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 10 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ant Flat soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ant Flat spot on the map
Rated from the USDA soil survey record for Ant Flat loam, 6 to 15 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (32.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 A loam layer about 0 to 7 in down: about 21% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerB1 A clay loam layer about 7 to 10 in down: about 31% clay, moderate plasticity when wet, dark reddish gray when moist. Possible
- Clay-rich layerB2tbest layer A clay loam layer about 10 to 26 in down: about 38% clay, high plasticity when wet, yellowish red when moist. Strong lead
- Loamy layerC1k A clay loam layer about 26 to 35 in down: about 31% clay, moderate plasticity when wet, yellowish red when moist. Promising
- Loamy layerC2 A clay loam layer about 35 to 60 in down: about 31% clay, moderate plasticity when wet, reddish yellow when moist. Promising
What it looks like raw
The clay-rich layer (B2t), 10 to 26 in down in the typical profile: yellowish red (2.5YR 5/6), yellowish red (2.5YR 4/6) moist; extremely hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium derived from sandstone.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Mountain areas of north-central Utah and southeastern Idaho. The series is moderately extensive.
USDA, geographic setting: Ant Flat soils are on fan terraces and gently rolling to steep mountain slopes. Elevations range from 4,700 to 8,200 feet. Slopes range from 0 to 45 percent. These soils formed in colluvium and alluvium from calcareous sandstone and some quartzite, conglomerate, limestone or shale. The climate is moist subhumid, with warm dry summers and cold moist winters. The mean annual precipitation is dominantly 16 to 25 inches but ranges from 14 to 25 inches. The mean annual temperature ranges from 35 to 45 degrees F., and the mean summer temperature ranges from 57 to 66 degrees F. The freeze-free period ranges from 60 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
- Manila: Strong lead
See it on the map
Open a Ant Flat spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ant Flat loam, 6 to 15 percent slopes, map unit AnD in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Ant Flat(revised 05/2001), established.
- Taxonomic class: Fine, smectitic, frigid Calcic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.