Hawkins soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 37 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hawkins soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hawkins spot on the map
Rated from the USDA soil survey record for Hawkins silty clay, 3 to 6 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- Clay-rich layerA1 A silty clay layer about 0 to 7 in down: about 45% clay, high plasticity when wet, very dark grayish brown when moist. Promising
- Clay-rich layerB1, B21best layer A silty clay layer about 7 to 37 in down: about 48% clay, high plasticity when wet, dark grayish-brown when moist. Strong lead
- Loamy layerC1k, C2k A loam layer about 37 to 60 in down: about 24% clay, moderate plasticity when wet, grayish brown when moist. Possible
What it looks like raw
The clay-rich layer (B1, B21), 7 to 37 in down in the typical profile: dark grayish-brown (10YR 4/2), pale brown (10YR 6/3) dry; extremely hard, extremely firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium and/or colluvium derived from tuffaceous sandstone.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is moderately extensive.
USDA, geographic setting: Hawkins soils are at elevations of 4,850 to 6,600 feet. They occur on foothill slopes, alluvial fans, and high lake terraces. Slope gradients are 3 to 30 percent. These soils formed in residuum and alluvium weathered from tuffaceous sandstone and tuffaceous limestone. The climate is moist subhumid and the average annual precipitation ranges from 18 to 25 inches. The mean annual temperature is 42 to 45 degrees F. The mean summer temperature is 60 to 66 degrees F., and the frost-free period ranges from 80 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
- Manila: Strong lead
See it on the map
Open a Hawkins spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hawkins silty clay, 3 to 6 percent slopes, map unit HbC in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Hawkins(revised 03/1999), established.
- Taxonomic class: Fine, smectitic, frigid Typic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.