Isbell soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 25 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Isbell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Isbell loam, 40 to 60 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 25 in (64 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 8 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerB21t, B22t A clay loam layer about 8 to 25 in down: about 31% clay, moderate plasticity when wet, very dark grayish brown when moist. Promising
- Clay-rich layerC1, C2best layer A silty clay layer about 25 to 48 in down: about 45% clay, high plasticity when wet, olive brown when moist. Strong lead
- Loamy layerC3 A loam layer about 48 to 60 in down: about 23% clay, moderate plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The clay-rich layer (C1, C2), 25 to 48 in down in the typical profile: olive brown (2.5Y 4/4), pale brown (10YR 6/3) dry; extremely hard, very firm, sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium and/or colluvium derived from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Isbell soils are of small extent in northern and central Utah; MLRA 47
USDA, geographic setting: Landform--mountain slopes, alluvial fans, and stream terraces
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Manila: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Isbell loam, 40 to 60 percent slopes, map unit IbG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Isbell(revised 01/2023), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.