Broadhead soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 17 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Broadhead soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Broadhead spot on the map
Rated from the USDA soil survey record for Broadhead clay loam, 2 to 5 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A clay loam layer about 0 to 6 in down: about 31% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- TopsoilA12 A clay loam layer about 6 to 17 in down: about 31% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Clay-rich layerB21t, B22tbest layer A silty clay layer about 17 to 43 in down: about 48% clay, high plasticity when wet, brown when moist. Strong lead
- Loamy layerB3tk, Ck A clay loam layer about 43 to 60 in down: about 31% clay, moderate plasticity when wet, pale brown when moist. Promising
What it looks like raw
The clay-rich layer (B21t, B22t), 17 to 43 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; extremely hard, extremely firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from limestone, sandstone and quartzite.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Wasatch Mountains of north-central Utah and south eastern Idaho. Moderately extensive. MLRA 13, 28A, and 47.
USDA, geographic setting: Broadhead soils are on fan remnants, hills, and sloping to very steep mountain slopes at elevations of 5,000 to 7,500 feet. Slopes are 0 to 70 percent. The soils formed in glacial drift, colluvium and alluvium derived mainly from mixed intermediate igneous parent rocks and some sandstone and quartzite. The climate is moist subhumid. The mean annual temperature is 41 to 45 degrees F. the mean summer temperature is about 63 to 65 degrees F. Average annual precipitation is about 15 to 25 inches. The freeze-free period is about 50 to 110 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
- Manila: Strong lead
See it on the map
Open a Broadhead spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Broadhead clay loam, 2 to 5 percent slopes, map unit BeB in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Broadhead(revised 05/2000), established.
- Taxonomic class: Fine, smectitic, frigid Pachic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.