Abbott soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 6 to 27 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Abbott soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Abbott clay (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (32.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 21 in (54 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA1 A clay layer about 0 to 6 in down: about 50% clay, high plasticity when wet, gray when moist. Strong lead
- Clay-rich layerC1best layer A clay layer about 6 to 27 in down: about 50% clay, high plasticity when wet, gray when moist. Strong lead
- Loamy layerIIC2 A sandy clay loam layer about 27 to 46 in down: about 28% clay, moderate plasticity when wet, gray when moist. Promising
- Sandy layer111C3 A loamy very fine sand layer about 46 to 61 in down: about 5% clay, low plasticity when wet, light olive gray when moist. Weak indication
What it looks like raw
The clay-rich layer (C1), 6 to 27 in down in the typical profile: gray (2.5Y 6/1), gray (2.5Y 5/1) moist; extremely hard, very firm, moderately sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Western Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Abbott soils are on flood plains, lake plains, and deltas. These soils formed in alluvium and lacustrine deposits derived from mixed sources. Slopes are 0 to 3 percent. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 6 to 9 inches, the mean annual air temperature is 46 to 52 degrees F., and the frost-free period is 120 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Airport: Strong lead
- Eimarsh: Strong lead
- Kirkham: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Arave: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Abbott clay, map unit Aa in Davis-Weber Area, Utah.
- Official Series Description: Abbott(revised 12/2006), established.
- Taxonomic class: Fine, smectitic, calcareous, mesic Vertic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.