Kirkham soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 13 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kirkham soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kirkham spot on the map
Rated from the USDA soil survey record for Kirkham-Airport complex, 0 to 2 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note Surface layer; expect roots and organic matter.
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A silty clay loam layer about 0 to 7 in down: about 34% clay, high plasticity when wet, grayish brown when moist. Possible
- Clay-rich layerA12best layer A silty clay layer about 7 to 13 in down: about 45% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Loamy layerC1 A silty clay loam layer about 13 to 34 in down: about 34% clay, high plasticity when wet, light brownish gray when moist. Promising
- Loamy layerC2 A silt loam layer about 34 to 52 in down: about 19% clay, moderate plasticity when wet, pale brown when moist. Possible
- Sandy layerC3 A fine sandy loam layer about 52 to 68 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The clay-rich layer (A12), 7 to 13 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; extremely hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northern and west-central Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Kirkham soils are on smooth to undulating flood plains, flood plain steps, lake plains and alluvial fans. Slopes range from 0 to 2 percent. Elevations are 1,280 to 1,740 meters. These soils formed in stratified alluvium derived from quartzite, sandstone, limestone, gneiss, and granite. The climate is dry subhumid. The mean annual precipitation is 200 to 425 mm. The mean annual temperature is 7 to 10.5 degrees C., the mean summer temperature is 18.5 to 22.2 degrees C., and the frost-free period is 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abbott: Strong lead
- Airport: Strong lead
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Arave: Promising
See it on the map
Open a Kirkham spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kirkham-Airport complex, 0 to 2 percent slopes, map unit KX in Davis-Weber Area, Utah.
- Official Series Description: Kirkham(revised 03/2010), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Fluvaquentic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.