Arave soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 15 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Arave soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Arave silty clay loam, 0 to 1 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 28% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A silty clay loam layer about 0 to 4 in down: about 32% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerB2t A silty clay loam layer about 4 to 11 in down: about 31% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Loamy layerC1ca A silty clay loam layer about 11 to 15 in down: about 28% clay, moderate plasticity when wet, pale yellow when moist. Possible
- Loamy layerC2cabest layer A silty clay loam layer about 15 to 28 in down: about 31% clay, moderate plasticity when wet, light gray when moist. Promising
- Loamy layerC3ca A silty clay loam layer about 28 to 38 in down: about 32% clay, low plasticity when wet, light gray when moist. Possible
- Loamy layerC4 A silty clay loam layer about 38 to 60 in down: about 32% clay, low plasticity when wet, light gray when moist. Possible
What it looks like raw
The loamy layer (C2ca), 15 to 28 in down in the typical profile: light gray (5Y 7/2), light olive brown (2.5Y 5/4) moist; very hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits derived from sandstone and/or lacustrine deposits derived from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 9,300 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Arave soils are on lake plains and low lake terraces. These soils formed in lacustrine deposits derived mainly from limestone, shale, sandstone, and quartzite. Slopes are 0 to 1 percent. The climate is dry subhumid. The mean annual precipitation is 12 to 18 inches. The mean annual temperature is 45 to 51 degrees F. and the mean summer temperature is 68 to 72 degrees F. The frost-free period is 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Arave silty clay loam, 0 to 1 percent slopes, map unit AV in Box Elder County, Utah, Eastern Part.
- Official Series Description: Arave(revised 11/2005), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Aquic Natrixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.