Sunnyside soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 5 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sunnyside soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sunnyside spot on the map
Rated from the USDA soil survey record for Sunnyside-Urban land complex, 8 to 15 percent slopes (District of Columbia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12).
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A sandy clay loam layer about 5 to 28 in down: about 22% clay, moderate plasticity when wet, red when moist. Possible
- Sandy layerH3 A loamy fine sand layer about 28 to 60 in down: about 13% clay, low plasticity when wet, red when moist. Weak indication
What it looks like raw
The loamy layer (H2), 5 to 28 in down in the typical profile: red (2.5YR 4/6). Raw colour is not fired colour.
About the soil
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in District of Columbia, in these survey areas: District of Columbia.
By state: wild clay in District of Columbia.
USDA, distribution and extent: Maryland, District of Columbia, and Virginia; the series is moderately extensive.
USDA, geographic setting: Sunnyside soils are on uplands in the northern part of the inner Atlantic Coastal Plain. Slopes are complex and range from 0 to 50 percent. The soil formed in unconsolidated sandy sediments of low to moderate clay content and low silt content. The climate is humid temperate, mean annual temperature is 48 to 58 degrees F., and mean annual precipitation is 38 to 44 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Dunning: Strong lead
- Chillum: Promising
- Keyport: Promising
- Lindside: Promising
- Beltsville: Possible
- Fallsington: Possible
- Matapeake: Possible
See it on the map
Open a Sunnyside spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sunnyside-Urban land complex, 8 to 15 percent slopes, map unit SpC in District of Columbia.
- Official Series Description: Sunnyside(revised 11/2002), established.
- Taxonomic class: Fine-loamy, siliceous, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.