Fallsington soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 10 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fallsington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fallsington spot on the map
Rated from the USDA soil survey record for Fallsington sandy loams, 0 to 2 percent slopes, northern coastal plain (District of Columbia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- TopsoilA A sandy loam layer about 2 to 10 in down: about 12% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBtgbest layer A sandy clay loam layer about 10 to 32 in down: about 25% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerBCg A loamy sand layer about 32 to 39 in down: about 8% clay, low plasticity when wet, gray when moist. Weak indication
- Loamy layerCg1 A sandy clay loam layer about 39 to 46 in down: about 22% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerCg2 A sand layer about 46 to 80 in down: about 2% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The clay subsoil (Btg), 10 to 32 in down in the typical profile: light brownish gray (10YR 6/2); friable; moderately sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 10 map units in District of Columbia, Maryland, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; District of Columbia; Harford County Area, Maryland; Harford County, Aberdeen Proving Ground, Maryland; Prince George's County, Maryland.
By state: wild clay in District of Columbia,wild clay in Maryland.
USDA, distribution and extent: Distribution: New Jersey, Delaware, Maryland, and eastern Pennsylvania, and Virginia.
USDA, geographic setting: Landscape: Coastal Plain Upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Lenni: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Dunning: Strong lead
- Howell: Strong lead
See it on the map
Open a Fallsington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 48%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fallsington sandy loams, 0 to 2 percent slopes, northern coastal plain, map unit FaaA in District of Columbia.
- Official Series Description: Fallsington(revised 11/2015), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Endoaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.