Sorum soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 15 to 33 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sorum soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Sorum fine sandy loam, 0 to 6 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 15 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2best layer A clay loam layer about 15 to 33 in down: about 27% clay, moderate plasticity when wet, light brownish gray when moist. Promising
- Sandy layerH3 A sandy loam layer about 33 to 60 in down: about 15% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (H2), 15 to 33 in down in the typical profile: light brownish gray (2.5Y 6/2), grayish brown (2.5Y 5/2) moist; hard, friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Butte County, South Dakota.
By state: wild clay in South Dakota.
USDA, distribution and extent: Northwestern South Dakota. The series is of moderate extent.
USDA, geographic setting: Sorum soils are on nearly level to gently sloping terraces and fans. Surfaces are dominantly smooth and slope gradients range from 0 to 6 percent. The soils formed in loamy alluvium. Mean annual temperature ranges from 39 to 45 degrees F, and mean annual precipitation ranges from 14 to 15 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Arvada: Strong lead
- Belfield: Strong lead
- Bidman: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- McKenzie: Strong lead
- Pierre: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sorum fine sandy loam, 0 to 6 percent slopes, map unit SnB in Butte County, South Dakota.
- Official Series Description: Sorum, established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Aridic Natrustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.