Absher soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 5 to 15 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Absher soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Absher-Loburn fine sandy loams, 3 to 9 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 39% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (30): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 10 in (25 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 5 in down: about 14% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay loam layer about 5 to 15 in down: about 39% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Loamy layerH3 A sandy clay loam layer about 15 to 60 in down: about 34% clay, high plasticity when wet, very pale brown when moist. Promising
What it looks like raw
The clay-rich layer (H2), 5 to 15 in down in the typical profile: grayish brown (2.5Y 5/2), dark grayish brown (2.5Y 4/2) moist; extremely hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sedimentary rock and/or local alluvium derived from sedimentary rock.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: These soils are extensive throughout eastern Montana and in North Dakota, South Dakota, Colorado, and possibly Wyoming.
USDA, geographic setting: Landforms- alluvial fans; stream terraces; drainageways; sedimentary plains; till plains. Elevations- 2,000 to 5,200 feet. (Elevations extend up to 8,000 feet in Colorado and Wyoming.) Slope- 0 to 15 percent. Parent material - till, glaciofluvial deposits, and alluvium derived from a wide source of geologic materials. Climate- long, cold winters; moist springs; hot, dry summers. Mean annual precipitation - 10 to 14 inches. Mean annual air temperature - 40 to 45 degrees F. The mean January temperature is 10 to 25 degrees F, and the mean July temperature is 64 to 72 degrees F. Frost-free season - 95 to 135 days. (Precipitation is as low as 7 inches in Wyoming.)
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hisle: Strong lead
- Kyle: Strong lead
- Pierre: Strong lead
- Stetter: Strong lead
- Swanboy: Strong lead
- Winler: Strong lead
- Abor: Strong lead
- Arvada: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Absher-Loburn fine sandy loams, 3 to 9 percent slopes, map unit AbB in Butte County, South Dakota.
- Official Series Description: Absher(revised 10/1999), established.
- Taxonomic class: Fine, smectitic, frigid Leptic Torrertic Natrustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.