Swanboy soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 12 to 79 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Swanboy soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Swanboy spot on the map
Rated from the USDA soil survey record for Swanboy clay, 0 to 3 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 65% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (48): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 67 in (169 cm)).
- Note Typically starts within about 12 in (31 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 14%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA A clay layer about 0 to 1 in down: about 62% clay, high plasticity when wet, light olive gray when moist. Promising
- Clay-rich layerBss A clay layer about 1 to 6 in down: about 62% clay, high plasticity when wet, light gray when moist. Promising
- Clay-rich layerBssz A clay layer about 6 to 12 in down: about 65% clay, high plasticity when wet, light gray when moist. Strong lead
- Clay-rich layerCbest layer A clay layer about 12 to 79 in down: about 65% clay, high plasticity when wet, pale yellow when moist. Strong lead
What it looks like raw
The clay-rich layer (C), 12 to 79 in down in the typical profile: pale yellow (5Y 7/3), pale olive (5Y 6/3) moist; very hard, firm, sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium derived from shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: very-fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: South Dakota west of the Missouri River, and possible adjacent states to the south and west. The series is extensive.
USDA, geographic setting: Swanboy soils are nearly level to strongly sloping, have plane to concave surfaces, and are on upland valleys, fans, flats, and stream terraces. Gilai microrelief is in most areas. Slope gradients typically are less than 6 percent but range from 0 to 15 percent. They formed in dense clay alluvium. Mean annual air temperature ranges from 45 to 50 degrees F, and mean annual precipitation ranges from 14 to 24 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Pierre: Strong lead
- Stetter: Strong lead
- Winler: Strong lead
- Abor: Strong lead
- Arvada: Strong lead
See it on the map
Open a Swanboy spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Swanboy clay, 0 to 3 percent slopes, map unit SuA in Butte County, South Dakota.
- Official Series Description: Swanboy(revised 06/2002), established.
- Taxonomic class: Very-fine, smectitic, mesic Aridic Haplusterts
- Rated with rule version 2026-09-28.1; the method is on the About page.