Kyle soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 35 to 79 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kyle soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Kyle-Pierre clays, 0 to 6 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 63% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (45): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 43 in (110 cm)).
- Note Typically starts about 35 in (90 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 10%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA A clay layer about 0 to 4 in down: about 51% clay, high plasticity when wet, grayish brown when moist. Promising
- Clay-rich layerBw A clay layer about 4 to 20 in down: about 63% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerBss A clay layer about 20 to 35 in down: about 63% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerCbest layer A clay layer about 35 to 79 in down: about 63% clay, high plasticity when wet, pale olive when moist. Strong lead
What it looks like raw
The clay-rich layer (C), 35 to 79 in down in the typical profile: pale olive (5Y 6/3), olive (5Y 5/3) moist; very hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from clayey shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: very-fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Western South Dakota, northwest Nebraska, and eastern Wyoming. The series is extensive.
USDA, geographic setting: Kyle soils are nearly level to strongly sloping on uplands and colluvial fans. Slopes are plane to convex, and slope gradients range from 0 to 15 percent. Gilgai microrelief is in most areas. The soil formed in clayey sediments weathered from calcareous clay shale. Mean annual air temperature ranges from 45 to 53 degrees F, and mean annual precipitation ranges from about 12 to 19 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Hisle: Strong lead
- Pierre: Strong lead
- Stetter: Strong lead
- Swanboy: Strong lead
- Winler: Strong lead
- Abor: Strong lead
- Arvada: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kyle-Pierre clays, 0 to 6 percent slopes, map unit KuB in Butte County, South Dakota.
- Official Series Description: Kyle, established.
- Taxonomic class: Very-fine, smectitic, mesic Aridic Haplusterts
- Rated with rule version 2026-09-28.1; the method is on the About page.