Arvada soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 15 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Arvada soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Arvada loam, 0 to 3 percent slopes (Adams County Area, Parts of Adams and Denver Counties, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 2 in down: about 21% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerH2 A sandy loam layer about 2 to 4 in down: about 18% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Clay-rich layerH3 A clay layer about 4 to 15 in down: about 48% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerH4best layer A sandy clay layer about 15 to 28 in down: about 48% clay, high plasticity when wet, light yellowish brown when moist. Strong lead
- Sandy layerH5 A sandy loam layer about 28 to 60 in down: about 15% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The clay-rich layer (H4), 15 to 28 in down in the typical profile: light yellowish brown (2.5Y 6/3), light olive brown (2.5Y 5/3) moist; hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Colorado, South Dakota, in these survey areas: Adams County Area, Parts of Adams and Denver Counties, Colorado; Butte County, South Dakota.
By state: wild clay in Colorado,wild clay in South Dakota.
USDA, distribution and extent: Eastern Wyoming, eastern Colorado and parts of adjacent states. The series is extensive.
USDA, geographic setting: The Arvada soils are on alluvial fans, fan remnants, terraces and hillslopes. The soils formed in moderately fine textured alluvium and colluvium derived from sedimentary rocks. Slopes range from 0 to 25 percent. Elevations range from 2,600 to 6,000 feet. The average annual precipitation is about 12 inches but ranges from 9 to 14 inches with about half the precipitation occurring during April, May, and early June. The mean annual air temperature is about 43 to 53 degrees F., and the mean summer temperature is 63 degrees F. The frost-free season is estimated to range from 100 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Belfield: Strong lead
- Bidman: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- McKenzie: Strong lead
- Nunn: Strong lead
- Pierre: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Arvada loam, 0 to 3 percent slopes, map unit AdB in Adams County Area, Parts of Adams and Denver Counties, Colorado.
- Official Series Description: Arvada(revised 12/2003), established.
- Taxonomic class: Fine, smectitic, mesic Ustertic Natrargids
- Rated with rule version 2026-09-28.1; the method is on the About page.