Hisle soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 15 to 35 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hisle soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Hisle loam, 0 to 9 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note High shrink-swell (linear extensibility about 9.4%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAE A loam layer about 0 to 2 in down: about 22% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Clay subsoilBtn A clay layer about 2 to 15 in down: about 50% clay, high plasticity when wet, light brownish gray when moist. Strong lead
- Clay-rich layerBkznbest layer A clay layer about 15 to 35 in down: about 48% clay, high plasticity when wet, gray when moist. Strong lead
- BedrockCr Bedrock about 35 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (Bkzn), 15 to 35 in down in the typical profile: gray (5Y 5/1). Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium derived from shale over clayey residuum weathered from shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Western South Dakota and possibly eastern Wyoming and northwestern Nebraska. The series is of moderate extent.
USDA, geographic setting: Hisle soils are nearly level to moderately sloping on uplands. Slope gradients range from 0 to 15 percent. Hisle soils formed in clays transported locally or weathered in place from clay shales. The mean annual soil temperature ranges from 45 to 53 degrees F, and mean annual precipitation ranges from 12 to 16 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Kyle: Strong lead
- Pierre: Strong lead
- Stetter: Strong lead
- Swanboy: Strong lead
- Winler: Strong lead
- Abor: Strong lead
- Arvada: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hisle loam, 0 to 9 percent slopes, map unit HlB in Butte County, South Dakota.
- Official Series Description: Hisle, established.
- Taxonomic class: Fine, smectitic, mesic Leptic Torrertic Natrustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.