Pierre soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 5 to 19 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pierre soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Pierre clay, 2 to 6 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 51% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (36): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 10.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerA A clay layer about 0 to 5 in down: about 48% clay, high plasticity when wet, dark grayish brown when moist. Promising
- Clay-rich layerBwbest layer A clay layer about 5 to 19 in down: about 51% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerBk A clay layer about 19 to 26 in down: about 52% clay, high plasticity when wet, olive gray when moist. Strong lead
- Clay-rich layerC A parachannery clay layer about 26 to 31 in down: about 52% clay, high plasticity when wet, gray when moist. Possible
- BedrockCr Bedrock about 31 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (Bw), 5 to 19 in down in the typical profile: grayish brown (2.5Y 5/2), dark grayish brown (2.5Y 4/2) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey residuum weathered from shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 31 in (79 cm) down.
Where it is mapped
Seen on the map as the most common soil in 7 map units in South Dakota, in these survey areas: Butte County, South Dakota; Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Pierre shale plains in western South Dakota, northeastern Wyoming, and northwestern Nebraska; LRR G, MLRA 60A. Pierre is still correlated in a few non-MLRA subets of MLRA 63A in west-central South Dakota. The series is of large extent.
USDA, geographic setting: Parent material: residuum or local alluvium over residuum from Cretaceous shale
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Stetter: Strong lead
- Swanboy: Strong lead
- Winler: Strong lead
- Abor: Strong lead
- Arvada: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pierre clay, 2 to 6 percent slopes, map unit PrB in Butte County, South Dakota.
- Official Series Description: Pierre(revised 02/2015), established.
- Taxonomic class: Fine, smectitic, mesic Torrertic Haplustepts
- Rated with rule version 2026-09-28.1; the method is on the About page.