Bidman soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 19 to 46 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bidman soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bidman loam, 0 to 2 percent slopes (Butte County, South Dakota) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (24): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerE A loam layer about 0 to 6 in down: about 22% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Clay subsoilBt A clay layer about 6 to 19 in down: about 43% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerBkbest layer A clay loam layer about 19 to 46 in down: about 35% clay, high plasticity when wet, light olive brown when moist. Strong lead
- Loamy layerC A clay loam layer about 46 to 79 in down: about 29% clay, high plasticity when wet, light olive brown when moist. Promising
What it looks like raw
The clay-rich layer (Bk), 19 to 46 in down in the typical profile: light olive brown (2.5Y 5/3), olive brown (2.5Y 4/3) moist; hard, very friable, sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in South Dakota, in these survey areas: Butte County, South Dakota.
By state: wild clay in South Dakota.
USDA, distribution and extent: Northeastern and central Wyoming and western South Dakota. The series is of moderate extent.
USDA, geographic setting: The Bidman soils are on alluvial fans, fan remnants, terraces, ridges and hills. Elevation is 2,600 to 6,000 feet. Slopes range from 0 to 25 percent. These soils formed in thick, calcareous alluvial sediments derived from sedimentary rock. At the type location the mean annual temperature is 47 degrees F., and the mean summer temperature is 66 degrees F. The average annual precipitation is about 12 inches with about half the precipitation in April, May, and June. Precipitation ranges from 10 to 14 inches. The frost-free season is 100 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Absher: Strong lead
- Arvada: Strong lead
- Belfield: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- McKenzie: Strong lead
- Pierre: Strong lead
- Sage: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bidman loam, 0 to 2 percent slopes, map unit BmA in Butte County, South Dakota.
- Official Series Description: Bidman(revised 11/2005), established.
- Taxonomic class: Fine, smectitic, mesic Ustic Paleargids
- Rated with rule version 2026-09-28.1; the method is on the About page.