Roanhide soil
Wild-clay potential
Weak indication
Weak indication: no layer of Roanhide shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Roanhide soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Roanhide spot on the map
Rated from the USDA soil survey record for Roanhide-Bauscher association, 10 to 30 percent slopes (Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Note Moderate engineering plasticity index (8).
- Note The official series description calls the wet soil slightly sticky.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- TopsoilA A sandy loam layer about 0 to 8 in down: about 13% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBCbest layer A sandy loam layer about 8 to 32 in down: about 13% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- BedrockR Bedrock about 32 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (BC), 8 to 32 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, very friable; slightly sticky. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium derived from igneous rock and/or colluvium derived from igneous rock over residuum weathered from igneous rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties; South Idaho Forests, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: South-central Idaho. The series is moderately extensive.
USDA, geographic setting: Roanhide soils are on hills or mountains and have slopes of 4 to 60 percent. They formed in material wathered from granite, quartz monzonite, and other intrusive igneous rocks. Elevations are 4,000 to 6,800 feet. Average annual precipitation is 12 to 20 inches. Average annual temperature ranges from 39 to 43 degrees F. Frost-free period is 60 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Chilcott: Strong lead
- Kunaton: Strong lead
- Blackwell: Promising
- Catherine: Promising
- Farrot: Promising
- Haw: Promising
- Simonton: Promising
See it on the map
Open a Roanhide spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Roanhide-Bauscher association, 10 to 30 percent slopes, map unit 130 in Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
- Official Series Description: Roanhide(revised 10/2002), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, frigid Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.