Cabarton soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 16 to 40 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cabarton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cabarton spot on the map
Rated from the USDA soil survey record for Cabarton silty clay loam, frequently flooded, 0 to 5 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (34): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note Surface layer; expect roots and organic matter.
- Note High shrink-swell (linear extensibility about 9.8%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilAp A silty clay loam layer about 0 to 12 in down: about 34% clay, high plasticity when wet, gray when moist. Possible
- Sandy layer2C A silt layer about 12 to 16 in down: about 5% clay, low plasticity when wet, light gray when moist. Weak indication
- Clay-rich layer3Agbbest layer A clay layer about 16 to 40 in down: about 48% clay, high plasticity when wet, dark gray when moist. Strong lead
- Clay-rich layer3Cg A clay loam layer about 40 to 60 in down: about 35% clay, high plasticity when wet, gray when moist. Strong lead
What it looks like raw
The clay-rich layer (3Agb), 16 to 40 in down in the typical profile: dark gray (10YR 4/1), black (N 2/) moist; very hard, extremely firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Distributed in the cold, high mountain valleys, mainly in Valley County, Idaho. The soil is inextensive.
USDA, geographic setting: Cabarton soils are on low alluvial fans and drainageways. Slopes are 0 to 5 percent. The soils formed in mixed alluvium from acid igneous and basic igneous rocks. Elevations are 3,800 to 5,200 feet. The climate is humid continental, cool summers (Trewartha's modified Koppen system) with moist, cold winters and dry summers. Average annual precipitation is 20 to 24 inches. Average January temperature is 20 degrees F; average July temperature is 64 degrees F. Mean annual temperature is 36 to 43 degrees F. Frost-free season is about 60 to 75 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Nisula: Promising
- Ticanot: Possible
- Archabal: Possible
See it on the map
Open a Cabarton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cabarton silty clay loam, frequently flooded, 0 to 5 percent slopes, map unit 29 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Cabarton, established.
- Taxonomic class: Fine, smectitic Typic Cryaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.