Blackwell soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 29 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Blackwell soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Blackwell spot on the map
Rated from the USDA soil survey record for Blackwell clay loam, frequently flooded, 0 to 5 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 32% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 9 in (23 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- TopsoilA A clay loam layer about 0 to 20 in down: about 32% clay, high plasticity when wet, dark gray when moist. Possible
- Sandy layerCg1 A silt loam layer about 20 to 29 in down: about 10% clay, low plasticity when wet, gray when moist. Weak indication
- Loamy layerCg2best layer A clay loam layer about 29 to 38 in down: about 32% clay, high plasticity when wet, gray when moist. Promising
- Sandy layer2C A stratified gravelly sand to sandy clay loam layer about 38 to 60 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (Cg2), 29 to 38 in down in the typical profile: gray (10YR 6/1), dark gray (10YR 4/1) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Mountainous areas of Colorado, Idaho, and Nevada. The series is of moderate extent.
USDA, geographic setting: The Blackwell soils are on bottomlands, stream terraces and alluvial fans and have slopes of 0 to 5 percent. Elevations range from 3,800 to 9,000 feet and range from 9,100 to 10,600 feet in Colorado. These soils formed in alluvium derived from basic igneous and acid igneous rocks. Average annual precipitation is 15 to 30 inches. Average annual temperature is 39 to 42 degrees F. The frost free season is 50 to 70 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Nisula: Promising
- Ticanot: Possible
- Archabal: Possible
See it on the map
Open a Blackwell spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Blackwell clay loam, frequently flooded, 0 to 5 percent slopes, map unit 19 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Blackwell(revised 11/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive Typic Cryaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.