Sudpeak soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 28 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sudpeak soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sudpeak spot on the map
Rated from the USDA soil survey record for Sudpeak loam, 3 to 20 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (29): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 32 in (81 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A loam layer about 0 to 18 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt A clay loam layer about 18 to 28 in down: about 32% clay, high plasticity when wet, brown when moist. Promising
- Clay-rich layerCgbest layer A silty clay loam layer about 28 to 60 in down: about 35% clay, high plasticity when wet, very pale brown when moist. Strong lead
What it looks like raw
The clay-rich layer (Cg), 28 to 60 in down in the typical profile: very pale brown (10YR 7/3), grayish brown (10YR 5/2) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Central and southeastern Idaho. These soils are not extensive.
USDA, geographic setting: Sudpeak soils are on alluvial and colluvial fan terraces and terraces of small mountain streams and have slopes of 0 to 20 percent. They have formed in alluvium and colluvium from basalt and other igneous rocks. Elevation is 3,800 to 6,600 feet. Average annual temperature is 36 to 46 degrees F. Average annual precipitation is 22 to 26 inches. Frost free season is 40 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Blackwell: Promising
- Culdecole: Promising
- Swede: Promising
- Ticanot: Possible
- Bluebell: Weak indication
- Brody: Weak indication
- Bryan: Weak indication
See it on the map
Open a Sudpeak spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sudpeak loam, 3 to 20 percent slopes, map unit 192 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Sudpeak(revised 03/2002), established.
- Taxonomic class: Fine, smectitic Vertic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.