Brody soil
Wild-clay potential
Weak indication
Weak indication: no layer of Brody shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brody soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Brody-Culdecole complex, 30 to 65 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (16).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 17 in (44 cm) of the surface.
- Lowers the potential High rock content (about 49% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 2 to 3 in down, not a clay body. Weak indication
- Sandy layerBs An ashy loam layer about 3 to 17 in down: about 13% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBCsbest layer A very gravelly loam layer about 17 to 38 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockR Bedrock about 38 to 48 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (BCs), 17 to 38 in down in the typical profile: brown (7.5YR 5/4), dark brown (7.5YR 3/4) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over colluvium and residuum weathered from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: ashy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 38 in (97 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Brody soils are moderately extensive in north central Idaho and the surrounding regions; MLRAs 43B and 43C
USDA, geographic setting: Landform--mountains
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Ticanot: Possible
- Brownlee: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brody-Culdecole complex, 30 to 65 percent slopes, map unit 23 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Brody(revised 08/2022), established.
- Taxonomic class: Ashy-skeletal, mixed Typic Vitricryands
- Rated with rule version 2026-09-28.1; the method is on the About page.