Ticanot soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 5 to 15 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ticanot soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ticanot spot on the map
Rated from the USDA soil survey record for Ticanot very cobbly loam, 4 to 65 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (29): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 10 in (25 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Lowers the potential High rock content (about 42% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A very cobbly loam layer about 0 to 5 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtbest layer A very cobbly clay layer about 5 to 15 in down: about 40% clay, high plasticity when wet, brown when moist. Possible
- BedrockR Bedrock about 15 to 25 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 5 to 15 in down in the typical profile: brown (10YR 4/3), dark brown (7.5YR 3/2) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and/or residuum weathered from basalt.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 15 in (38 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Ticanot soils are of moderate extent in central and southeastern Idaho; MLRA 43B.
USDA, geographic setting: Landform--mountain slopes
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Brownlee: Possible
- Bluebell: Weak indication
See it on the map
Open a Ticanot spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ticanot very cobbly loam, 4 to 65 percent slopes, map unit 195 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Ticanot(revised 10/2026), established.
- Taxonomic class: Clayey-skeletal, smectitic Lithic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.