Swede soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 13 to 52 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Swede soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Swede loam, 4 to 12 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 13 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBt1best layer A clay loam layer about 13 to 52 in down: about 30% clay, high plasticity when wet, pale brown when moist. Promising
- Clay subsoilBt2 A gravelly clay loam layer about 52 to 60 in down: about 30% clay, high plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 13 to 52 in down in the typical profile: pale brown (10YR 6/3), brown (7.5YR 5/4) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite and/or basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Distributed in the colder areas of the Idaho Batholith bordering the valley floors. The soil is inextensive.
USDA, geographic setting: Swede soils are on alluvial fans and footslopes. Slopes are 1 to 60 percent. The soils formed in mixed alluvial material from basaltic and granitic sources. Elevations are 4,100 to 5,300 feet. The climate is subhumid having warm, dry summers and cold, wet winters. The average annual precipitation is 24 to 27 inches and includes 8 to 11 feet of snowfall. The average annual temperature is 39 to 43 degrees F. The frost-free season is about 60 to 75 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Catherine: Promising
- Culdecole: Promising
- Nisula: Promising
- Ticanot: Possible
- Archabal: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Swede loam, 4 to 12 percent slopes, map unit 193 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Swede(revised 08/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive Typic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.