Archabal soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 14 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Archabal soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Archabal spot on the map
Rated from the USDA soil survey record for Archabal loam, 0 to 2 percent slopes (Valley Area, Idaho, Parts of Adams and Valley Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 14 in down: about 22% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1best layer A loam layer about 14 to 31 in down: about 22% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Clay subsoilBt2 A coarse sandy loam layer about 31 to 52 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerC A coarse sand layer about 52 to 60 in down: about 7% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 14 to 31 in down in the typical profile: yellowish brown (10YR 5/4), dark brown (7.5YR 3/3) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Central Idaho in the cooler areas of the Idaho Batholith. The soils are inextensive.
USDA, geographic setting: Archabal soils are on moderately dissected glacial outwash or alluvial terraces, fans, or plains. Slopes are 0 to 20 percent. The soils formed in mixed acid igneous and minor amounts of basic igneous material. Elevations are 4,800 to 5,000 feet. The climate is humid continental, cool summer (Trewartha's modified Koppen System), with moist, cold winters and dry summers. Mean annual precipitation is 22 to 24 inches. Average January temperature is 20 degrees F.; average July temperature is 64 degrees F. Mean annual temperature is 40 degrees to 45 degrees F. Frost-free season is about 60 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Blackwell: Promising
- Nisula: Promising
- Swede: Promising
- Tica: Possible
- Bluebell: Weak indication
- Bryan: Weak indication
- Demast: Weak indication
See it on the map
Open a Archabal spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Archabal loam, 0 to 2 percent slopes, map unit 1 in Valley Area, Idaho, Parts of Adams and Valley Counties.
- Official Series Description: Archabal(revised 03/2008), established.
- Taxonomic class: Fine-loamy, mixed, superactive Typic Humicryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.