Demast soil
Wild-clay potential
Weak indication
Weak indication: no layer of Demast shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Demast soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Demast loam, 10 to 30 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 32% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A loam layer about 0 to 20 in down: about 20% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Clay subsoilBt1best layer A gravelly loam layer about 20 to 51 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt2 A very gravelly loam layer about 51 to 60 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 20 to 51 in down in the typical profile: brown (7.5YR 4/3), dark brown (7.5YR 3/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum weathered from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: The series is moderately extensive in southern and western Idaho and in central Montana. MLRA 43B.
USDA, geographic setting: The soils are principally on steep and very steep northerly mountain slopes at elevations of 4,000 to 8,000 feet. Most slopes are between about 30 and 50 percent, but the slopes range from 10 to 80 percent. The soils formed in material weathered from basalt and other closely related volcanic rocks. The climate is cool subhumid and has an average annual precipitation of 18 to 25 inches, including 8 to 12 feet of snowfall. Average annual temperature is 35 to 41 degrees F. Frost-free season is about 60 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Nisula: Promising
- Ticanot: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Demast loam, 10 to 30 percent slopes, map unit 40 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Demast(revised 12/2022), established.
- Taxonomic class: Fine-loamy, mixed, superactive Pachic Argicryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.