Farrot soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 10 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Farrot soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Farrot-Haw complex, 20 to 50 percent slopes (Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilA A coarse sandy loam layer about 0 to 10 in down: about 13% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A sandy clay loam layer about 10 to 24 in down: about 30% clay, high plasticity when wet, brown when moist. Promising
- Sandy layerC A very gravelly coarse sandy loam layer about 24 to 30 in down: about 10% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- BedrockR Bedrock about 30 to 40 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 10 to 24 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; very hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium over bedrock derived from igneous rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho. The soils are moderately extensive.
USDA, geographic setting: Farrot soils are on foothills at elevations of 3,600 to 5,000 feet. These soils formed in alluvium and residuum from intermediate intrusive rocks. Slopes are 0 to 60 percent. The average annual precipitation is 12 to 14 inches and the average annual temperature is 46 to 50 degrees F. The frost-free season is 85 to 120 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Kunaton: Strong lead
- Haw: Promising
- Simonton: Promising
- Brownlee: Possible
- Colthorp: Possible
- Elkcreek: Possible
- Lankbush: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Farrot-Haw complex, 20 to 50 percent slopes, map unit 59 in Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
- Official Series Description: Farrot(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.