Elkcreek soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 4 to 10 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Elkcreek soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Elkcreek spot on the map
Rated from the USDA soil survey record for Elkcreek-Gaib-Simonton complex, 12 to 30 percent slopes (Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 32% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 22% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA A stony loam layer about 0 to 4 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1best layer A stony clay loam layer about 4 to 10 in down: about 32% clay, high plasticity when wet, brown when moist. Possible
- Clay subsoilBt2 A stony loam layer about 10 to 22 in down: about 23% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- BedrockR Bedrock about 22 to 32 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt1), 4 to 10 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3), dark brown (10YR 4/3) rubbed; hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and/or alluvium over bedrock derived from volcanic rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 22 in (56 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: South-central Idaho. The series is of moderate extent.
USDA, geographic setting: Elkcreek soils are on foothills and mountainsides and have slopes of 0 to 60 percent. Elevation is 4,500 to 6,500 feet. The soils formed in loess and residuum and alluvium derived from igneous rock. The soils formed in a continental climate having cool dry summers and cold wet winters. Average annual precipitation is 12 to 18 inches and the average annual air temperature is 40 to 45 degrees F. The frost-free period is 60 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Kunaton: Strong lead
- Farrot: Promising
- Haw: Promising
- Simonton: Promising
- Brownlee: Possible
- Colthorp: Possible
- Lankbush: Possible
See it on the map
Open a Elkcreek spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 40%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Elkcreek-Gaib-Simonton complex, 12 to 30 percent slopes, map unit 58 in Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
- Official Series Description: Elkcreek(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Ultic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.