Haw soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 14 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Haw soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Haw-Lankbush complex, 15 to 25 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btk" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 16 in (40 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A loam layer about 0 to 7 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 7 to 14 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBtkbest layer A clay loam layer about 14 to 30 in down: about 28% clay, high plasticity when wet, brown when moist. Promising
- Sandy layerBk1 A loam layer about 30 to 38 in down: about 18% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layer2Bk2 A loamy sand layer about 38 to 64 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The clay subsoil (Btk), 14 to 30 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; very hard, very firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or lacustrine deposits and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho; Elmore County Area, Idaho, Parts of Elmore and Owyhee Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho and Utah. MLRA 11 and 25 in Idaho. Haw soils are extensive.
USDA, geographic setting: Haw soils are level to steep on dissected terraces, foothills, alluvial fans, fan remnants and draw bottoms at elevations of 2,000 to 5,300 feet. Slopes range from 0 to 65 percent. These soils formed in coarse or moderately coarse textured, old unconsolidated or weakly consolidated lacustrine sediments derived mainly from intrusive igneous rocks and are commonly high in quartz, and in micaceous and feldspathic materials. A thin mantle of loessial material covers most of the sediments. The climate is cool and moist in the winter and hot and dry in the summer. Average annual precipitation ranges from 9 to 15 inches. Average annual temperature ranges from 45 to 51 degrees F. Frost-free period...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Chilcott: Strong lead
- Kunaton: Strong lead
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Haw-Lankbush complex, 15 to 25 percent slopes, map unit 69 in Ada County, Idaho.
- Official Series Description: Haw(revised 02/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Calciargidic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.