Bowns soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 7 to 15 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bowns soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bowns loam, 0 to 8 percent slopes, stony (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Note USDA labels this a "2Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (27): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 8 in (20 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 7.9%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A loam layer about 0 to 2 in down: about 16% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerE A loam layer about 2 to 7 in down: about 16% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Clay subsoil2Bt1best layer A silty clay loam layer about 7 to 15 in down: about 38% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay subsoil2Bt2 A silty clay layer about 15 to 20 in down: about 42% clay, high plasticity when wet, light yellowish brown when moist. Promising
- Clay subsoil2Btkn A silty clay layer about 20 to 28 in down: about 42% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Loamy layer2Bknq A loam layer about 28 to 35 in down: about 20% clay, moderate plasticity when wet, very pale brown when moist. Possible
- Bedrock3R Bedrock about 35 to 39 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (2Bt1), 7 to 15 in down in the typical profile: pale brown (10YR 6/3), dark yellowish brown (10YR 3/4) moist; slightly hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium and/or loess over bedrock derived from basalt.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Lithic bedrock typically about 35 in (89 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Ada County, Idaho; MLRA 11.. These soils are inextensive.
USDA, geographic setting: Bowns soils are on lava flow lobes on shield volcanoes. Elevations range from 3,000 to 3,200 feet. Slopes are 0 to 15 percent. These soils formed in a thin mantle of loess mixed with colluvium from basalt over silty alluvium from loess and weathered volcanic ash. The mean annual precipitation ranges from 8 to 9 inches. The mean annual temperature is 52 to 53 degrees F. The frost-free period is 140 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
- Chilcott: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bowns loam, 0 to 8 percent slopes, stony, map unit 10 in Ada County, Idaho.
- Official Series Description: Bowns(revised 10/2000), established.
- Taxonomic class: Fine, smectitic, mesic Xeric Paleargids
- Rated with rule version 2026-09-28.1; the method is on the About page.