Aradaran soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 29 to 42 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Aradaran soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Aradaran spot on the map
Rated from the USDA soil survey record for Aradaran-Yad-Gimmi complex, 4 to 35 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (37): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 5% by volume).
- Note High shrink-swell (linear extensibility about 10.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA1 A loam layer about 0 to 3 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A loam layer about 3 to 9 in down: about 22% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerBA A loam layer about 9 to 14 in down: about 22% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt1 A clay loam layer about 14 to 23 in down: about 35% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay subsoilBt2 A clay loam layer about 23 to 29 in down: about 38% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoilBt3best layer A clay layer about 29 to 42 in down: about 50% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay subsoilBt4 A fine gravelly clay loam layer about 42 to 55 in down: about 38% clay, high plasticity when wet, light yellowish brown when moist. Promising
- Clay subsoilBt5 A fine gravelly sandy clay loam layer about 55 to 60 in down: about 25% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 29 to 42 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho; Boise County Area, Idaho, Western Part.
By state: wild clay in Idaho.
USDA, distribution and extent: West-central Idaho. MLRA 10. Aradaran soils are of small extent.
USDA, geographic setting: Aradaran soils are on hill backslopes, footslopes, summits and shoulders at elevations of 3,400 to 4,200 feet. Slopes range from 4 to 35 percent. These soils formed in alluvium and colluvium from welded tuff and granitic rocks. Average annual precipitation is 15 to 19 inches. Average annual temperature is 47 to 49 degrees F. Frost-free period is 110 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hann: Strong lead
- McDesh: Strong lead
- Shafer: Strong lead
- Aldape: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
See it on the map
Open a Aradaran spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Aradaran-Yad-Gimmi complex, 4 to 35 percent slopes, map unit 6032 in Ada County, Idaho.
- Official Series Description: Aradaran(revised 03/2006), established.
- Taxonomic class: Fine, smectitic, mesic Pachic Ultic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.