Brent soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 18 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brent soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Brent loam, low rainfall, 0 to 2 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (35): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A loam layer about 0 to 18 in down: about 18% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A clay layer about 18 to 29 in down: about 48% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay subsoilBtk A clay layer about 29 to 40 in down: about 48% clay, high plasticity when wet, very pale brown when moist. Strong lead
- Clay-rich layer2Bk A gravelly clay loam layer about 40 to 46 in down: about 38% clay, high plasticity when wet, pink when moist. Promising
- Sandy layer3C A gravelly loamy coarse sand layer about 46 to 64 in down: about 7% clay, low plasticity when wet, pink when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 18 to 29 in down in the typical profile: grayish brown (10YR 5/2), dark grayish brown (10YR 4/2) moist; very hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from igneous rock.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Foothills of southwestern Idaho. The soils are inextensive.
USDA, geographic setting: Brent soils are on dissected fluviatile and lacustrine terraces. Elevations range from 2,700 feet to 4,000 feet. Slopes are 4 to 30 percent. The soils formed in unconsolidated or poorly consolidated material of dominantly acid igneous origin. They are in a middle latitude steppe (Trewartha's modified Koppen system) climate with dry summers and a mean annual precipitation ranging from 10 to 15 inches. Mean January temperature is about 27 degrees F.; mean July temperature is about 74 degrees F.; mean annual temperature is 48 degrees to 52 degrees F. Frost-free period is about 140 to 155 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
- Chilcott: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brent loam, low rainfall, 0 to 2 percent slopes, map unit 13 in Ada County, Idaho.
- Official Series Description: Brent(revised 05/2000), established.
- Taxonomic class: Fine, smectitic, mesic Xeric Paleargids
- Rated with rule version 2026-09-28.1; the method is on the About page.